How much you can deadlift: your 1RM
A 1RM equation estimates from a submaximal deadlift load. It is not a test: it is a number that depends on your technique and the day, published here with the caution the evidence requires.
Your percentage table
When you calculate, this shows what each percentage of your estimated 1RM (Epley) is. It is arithmetic, not a prescription.
| Percentage | Load |
|---|---|
| 50% | Not calculated |
| 55% | Not calculated |
| 60% | Not calculated |
| 65% | Not calculated |
| 70% | Not calculated |
| 75% | Not calculated |
| 80% | Not calculated |
| 85% | Not calculated |
| 90% | Not calculated |
| 95% | Not calculated |
Why this number? The 1RM is estimated with an equation linking the load you lift to the reps you perform. It is an estimate, not a test: it depends on technique and on the day, which is why the page shows the range of equations instead of a single figure. [1]
Result
Estimated 1RM
Your load is…
The other equations give
Load band
It is an ESTIMATE from a submaximal load and a number of reps, not a test. It depends on technique and on the day: two people with the same load can end up several kilos apart.
Copied.
The data you type is calculated in your browser and kept in the page address, so you can reload it or share the result. The image is drawn here too: nothing is uploaded to any server, neither when calculating nor when downloading it. It only leaves your browser when you share it.
The method, with its equation and its limits
The repetition counts if you lift the bar from the floor until standing tall, with knees extended and shoulders back.
Calculate your 1RM by exercise: bench press · squat
Where the equations come from
The full table (7 equations) is in a 2024 open-access article that also measures the real error of each one [1]. The second source [2] audits where each formula came from, and that is the datum that rules here.
Notation: w is the load in kg and r the number of completed reps. They all return kg.
- Brzycki (1993) ·
1RM = w / (1.0278 − 0.0278 × r)— no peer-reviewed study behind it: Richens & Cleather (2014): "not a piece of scientific research, but an article detailing strength testing" that does not say what the equation is based on. - Epley (1985) ·
1RM = w × (1 + r / 30)— no peer-reviewed study behind it: Table 1 of Beia et al. prints (1 + 0.333 × r) × w, which is a one-decimal-place error. The correct form is used here, verified in two sources (1rm.md §2.1). After the error, the formula is a printed chart. - Mayhew et al. (1995) ·
1RM = 100 × w / (52.2 + 41.9 × e^(−0.055 × r))— the only one with a peer-reviewed study behind it. - O'Connor et al. (1989) ·
1RM = w × (1 + 0.025 × r)— no peer-reviewed study behind it: It comes from a book, with no DOI. The most conservative of the five. - Wathen (1994) ·
1RM = 100 × w / (48.8 + 53.8 × e^(−0.075 × r))— no peer-reviewed study behind it: Richens & Cleather (2014): it is the previous edition of Baechle's book, which contains no peer-reviewed research on the 1RM table.
The Epley erratum, explained
The 2024 article prints Epley as (1 + 0.333 × r) × w. Applied literally it gives 266.5 kg from 100 kg × 5 reps: impossible. It is a decimal-place shift of ×10. The correct form, w × (1 + r / 30), gives 116.67 kg and is verified in two independent sources. The correct one is used here, which is why 100 kg × 5 comes out as 116.67 kg and not 266.5.
The two equations that are not here, and why
- Lander (1985): The sign of the denominator is unresolved: Beia et al. print 101.3 − 2.26123 × r and other citations use 101.3 + 2.26123 × r. What is more, Richens & Cleather (2014) document that it "began as a \"guess-timated\" chart that was eventually published without the author's knowledge".
- Kemmler/Lauber/Mayhew/Wassermann (2006): It was derived in postmenopausal women trained with osteoporosis. Publishing it for the general population would be extrapolating without support.
This leaves one of the seven rows uncoded (Lander) and another outside the general population (KLW 2006). They are not replaced with "approximations": an equation with no verified signature is not an equation.
What error has actually been measured
The study measured real 1RM and estimates in 17 men and 23 women aged 72.8 ± 7.4 years, all with osteopenia or osteoporosis, on machine exercises. All the equations except KLW overestimated the result: between 5.4 % and 12.9 % in the worst case (leg press). The repeatability of the test itself was 3.3 % to 5.4 %.
The caveat travels with the figure: that error comes from older adults with osteopenia. In a healthy population and on free-weight exercises there is no such figure, which is why this site does not publish "the error is X %" without that qualification.
The load band, with its literal definition
The bands shown come from the 2022 meta-analysis [3], which defines them as follows: very low (<30 % 1RM or >35RM), low (30-59 % or 16-35RM), moderate (60-79 % or 8-15RM) and high (≥80 % or ≤7RM). Only the last two are returned, because the other two are outside the rep range these equations can compute.
That same analysis finds an advantage for the high load when it comes to maximal strength and, by contrast, no difference between loads for hypertrophy: to gain strength, raise the load and lower the reps; to gain mass, volume matters more than the kilos [3].
The modern alternative, and why it is not offered here either
These equations are almost fifty years old. The route used today in place of the Epley or Brzycki table is the load-velocity relationship: you measure how fast you lift a submaximal load, and the 1RM is estimated from that. The review with the largest individual dataset in the area [4] examined 137 models from 26 studies and found two things that matter here. One: the estimation error is around 9.8 % [4]. Two, and it is the one that weighs most: the predictions tend to overestimate the 1RM, by around 4 % of the measured value [4].
In other words, the direction of the error matches what Beia measured [1]: all the available equations, old route or modern route, tend to say you can more than you can. The conclusion is the same: where possible, it is better to measure the 1RM directly.
This site does not offer the velocity-based method because it requires a velocity sensor, a strength protocol and a table of thresholds per exercise. Without that measurement there is nothing to compute: it would be one more screen full of invented numbers.
What this page does not do
- It does not say "you should be able to lift X kg". There is no support for it: the measured error reaches 12.9 % and depends on technique.
- It does not compare your estimate with an athlete's. The same 1RM % does not give the same number of reps across populations [2]: the resistance group did significantly more reps at the same intensity than the weightlifters.
- It does not extrapolate outside 1-12 reps. The table was built on the 5-8 rep range to failure.
Every caveat
- It is an ESTIMATE from a submaximal load and a number of reps, not a test. It depends on technique and on the day: two people with the same load can end up several kilos apart.
- No comparison has been found that says which of these equations is the most accurate in the general population, which is why this site recommends none: it offers them with their provenance and their note alongside.
- Four of the five equations do not come from peer-reviewed research: they are printed-chart formulas that circulated as reference tables (Richens & Cleather, 2014).
- The only study that measures the real error was done in 40 older adults with osteopenia or osteoporosis (72.8 ± 7.4 years) and on machine exercises. All the equations except Kemmler and colleagues (2006), which are not published here, overestimated the 1RM, and the largest difference measured was 5.4 to 12.9 % on the leg press. In a healthy population and on free weights there is no such figure.
- The same 1RM percentage does not give the same number of reps across populations: an estimate for a general user cannot be extrapolated to an athlete, nor the other way round (Richens & Cleather, 2014).
- With pain, an injury, a different technique, or after a few days off training, the estimate means nothing. It does not replace an assessment by a professional.
Sources 4 references
- Beia R, Wassermann A, Raps S, Mayhew J, Uder M, Kemmler W (2024) Developing Accurate Repetition Prediction Equations for Trained Older Adults with Osteopenia. Sports (Basel) 12(9):233. See source (opens in a new tab) DOI: 10.3390/sports12090233 Tabla 1 con las 7 ecuaciones de estimación de 1RM y medición del error de cada una en 40 adultos mayores con osteopenia (sobrestimación 5,4-12,9 %) Licence: Artículo de acceso abierto bajo CC BY 4.0. Se puede reproducir la tabla de ecuaciones citando la fuente. Consulted:
- Richens B, Cleather DJ (2014) The relationship between the number of repetitions performed at given intensities is different in endurance and strength trained athletes. Biology of Sport 31(2):157-161. See source (opens in a new tab) DOI: 10.5604/20831862.1099047 Auditoría de la procedencia real de las ecuaciones de 1RM (Epley, Lander y Brzycki no proceden de investigación revisada por pares) y evidencia de que el % 1RM se relaciona con un número de repeticiones distinto según población Licence: Artículo de acceso abierto bajo CC BY-NC-ND 4.0. Se cita con enlace; no se reproduce texto salvo cita breve verificable. Consulted:
- Carvalho L, Junior RM, Barreira J, et al. (2022) Muscle hypertrophy and strength gains after resistance training with different volume-matched loads: a systematic review and meta-analysis. Applied Physiology, Nutrition, and Metabolism 47(4):357-368. See source (opens in a new tab) DOI: 10.1139/apnm-2021-0515 Metaanálisis con cargas igualadas por volumen: fuerza sí depende de la carga, hipertrofia no Licence: Artículo de revista con derechos de autor. Se cita con enlace al editor; no se reproduce texto salvo cita breve verificable. Consulted:
- Greig L, Aspe RR, Hall A, Comfort P, Cooper K, Swinton PA (2023) The Predictive Validity of Individualised Load-Velocity Relationships for Predicting 1RM: A Systematic Review and Individual Participant Data Meta-analysis. Sports Medicine 53(9):1693-1708. See source (opens in a new tab) DOI: 10.1007/s40279-023-01854-9 Revisión sistemática con metaanálisis de datos individuales (26 estudios): la relación carga-velocidad sobreestima la 1RM; el error estándar es de alrededor del 9,8 % Licence: Artículo de revista con derechos de autor. Texto libre en PMC (PMC10432349). Se cita con enlace. Consulted: